"INFLUENCE OF BORINATION, BORON CEMENTATION OF STEEL 45 AND VISCOSITY OF A LUBRICANT ON THE PARAMETERS OF ADHESION BOND IN THE STEEL 45 - 40X SYSTEM "
DOI:
https://doi.org/10.31489/2021No2/67-75Keywords:
metal system, tangential strength, shear rate, piezoelectric coefficient, pressure, dynamic viscosityAbstract
"In the work, the regularities of changes in the shear strength of the adhesive bond τ and the piezoelectric coefficient β in the metal systems ""steel 45 - 40X"", ""steel 45+В-40Х"", ""steel 45+ВС-40Х"" were obtained during physical modeling of the materials I-20A, Wolf 10W-40, TAD-17i, Litol-24 with distinctive dynamic viscosities using the additional equipment of the SMTs-2 friction machine. It has been established that a twofold increase in the shear rate causes a decrease in the piezoelectric coefficient in the ""steel 45+VS - 40X"" system by a factor of 1.2-1.6 for Wolf 10W-40, TAD-17i, Litol-24 lubricants and its relative similarity independent of dynamic viscosity. At the same time, a twofold increase in the shear rate in the ""steel 45+B-40X"" system also causes a decrease in the piezoelectric coefficient by a factor of 1.16-1.38 for all tested lubricants and its alignments, as in the ""steel 45+VS"" system, does not observed. It was found that the clearly expressed regularity of the effect of the equivalent dynamic viscosity on the strength of the adhesive bond at p = 0 MPa is not revealed, and the nature of the manifestation is predetermined by a possible change in the mechanism of intermolecular interaction, which depends on the structure of the molecules of lubricants. It was determined that the piezoelectric coefficient naturally decreases with an increase in dynamic viscosity in the entire considered range of normal pressures. "
References
"1 Kubich V.I., Cherneta O.G., Yurov V.M. Potential difference of metal machine parts methodology for determining the parameters of adhesional properties of materials on the SMC-2 friction machine. Eurasian Physical Technical Journal, 2019, Vol.16, No.2(32), pp. 78 – 82.
Denisov A.S. Workshop on the technical operation of vehicles. Moscow, 2012, 280 p.
Rodionov Yu.V., Sevostyanov A.L. Basics of car repair. Penza: PGUAS, 2014, 300 p.
Cherneta O.G., Kubich V.I., Voloshchuk R.G., Averyanov V.S., Shmatko D.Z. Strengthening of the Restored Surface Layer of Steel Parts 45 by Laser Boring. International Journal of Engineering & Technology (UAE). Science Publishing Corporation, RAK Free Trade Zone. Vol 7, No.4.3 (2018), pp. 71 – 75.
Cherneta O.G., Kubich V.I., Shcherbina M.A., Averyanov V.S., Shmatko D.Z. Research of steel 45 strugging influence on the parameters of adhesion communication with chrome, chrome-nickel steel. Mathematical modeling. Kam’yanske. DDTU, 2019, No. 2 (41), pp. 150-158.
Bykova T.M. The influence of the chemical composition of steel on the structure and properties of diffusion boride coatings. Dissertation for the degree of candidate of technical sciences, Yekaterinburg, 2016, 164 p.
Kovalsky B.I. Methodology for monitoring and diagnostics of lubricants as elements of drive systems of multicomponent machines. Dissertation for the degree of Doctor of Technical Sciences, Krasnoyarsk, 2005, 418 p.
Davidyan L.V. Intensification of diffusion saturation with boron of carbon and alloy steels during microarc heating. Dissertation for the degree of candidate of technical sciences, Rostov-on-Don, 2019, 128 p.
Kragelsky I.V., Dobychin M.N., Kombalov V.S. Fundamentals of Friction and Wear Calculations. Moscow, Mechanical engineering, 1977, 526 p.
Semenov V.I., Shuster L.Sh., Chertovskikh S.V., et al. Influence of the complex parameter of plastic frictional contact and material structure on the strength of adhesive bonds. Friction and wear, 2005. Vol. 26, No.1, pp. 74 – 79.
Rabinowcz E. Surface Energy Approach to Friction and Wear. Product Engineering, 1965, Vol. 36, No 6, pp.95 – 99.
Kuznetsov V.D. Physics of cutting and friction of metals and crystals. Selected Works. Moscow, 1977, 310 p.
Johnson K. Mechanics of Contact Interaction. Moscow, Mir, 1989, 510 p.
Kubich V.I., Guchenko S.A., Yurov V.M., Zavatskaya O.N. On the coefficient of friction of high-entropy seven-atom alloys. 11th International Scientific. conference. “Chaos and structures in nonlinear systems. Theory and experiment"", Karaganda, 2019, pp. 114 – 118.
Musokhranov M.V., Kalmykov V.V., Malyshev E.N., Zenkin N.V. The energy of the surface layer of metals as a tool for influencing the value of the friction coefficient. Fundamental research, 2015, No. 2, pp. 251 – 254.
Musokhranov M.V., Kalmykov V.V., Logutenkova E.V., Sorokin S.P. Energy state of the surface layer of machine parts. Modern high technology, 2016, No. 5, pp. 276 – 279."
